| Description | The GLP-1A logic pulser can be used to perform in-circuit testing of TTL, CMOS, and many other logic devices at a maximum of 50MHz. The GLP-1A is enhanced with a logic probe function with a minimum detectable pulse width of 10 ns, providing enough sensitivity for most applications. A Short 10 sec pulse width assures that no damage will occur to circuits whilst testing. With a weight less than 50g, a non-slip grip, and an external sync input, GLP-1A provides comfort and reliability for various troubleshooting tasks. | | | | | |
| Content | | The GCP-425P four-channel current probe power supplies designed for the GCP-530 and GCP-1030 clamp current probes. The power supplies are ideal for when power is not available from an oscilloscope. Also use for general current measurement applications. | The GDP series probe provide 25MHz, 50MHz and 100MHz bandwidth, enabling users to safely make high-voltage measurements on floating circuit test. GDP series high-voltage differential probe converts floating signals to low-voltage ground-referenced signals that can be displayed safely and easily on any ground-referenced oscilloscope | | | The GCP-206P two-channel current probe power supplies designed for the GCP-530 and GCP-1030 clamp current probes. The power supplies are ideal for when power is not available from an oscilloscope. Also use for general current measurement applications. |
| Additional information |
| Weight |
1 lbs |
| Dimensions |
6 × 8 × 4 in |
|
| Weight |
4 lbs |
| Dimensions |
12 × 10 × 6 in |
|
| Weight |
2 lbs |
| Dimensions |
11 × 11.25 × 2.25 in |
|
| Weight |
0.3 lbs |
| Dimensions |
7 × 3 × 2 in |
|
| Weight |
0.3 lbs |
| Dimensions |
7 × 3 × 2 in |
|
| Weight |
4 lbs |
| Dimensions |
12 × 10 × 6 in |
|
