| Content | The Amprobe TMA40-A provides three measurements in one: Air Velocity or volume, Relative Humidity and Temperature. With three ways to view your measurement results. Choose between single point measurement, multiple points up to 99, or the added feature of data logging up to 2400 data points. User sets the measurement interval time from 1 to 200 seconds. The TMA40-A has a flexible cord to position vane where you need to measure. For accurate CFM results, the user simply inputs the area of the air source. TMA40-A ships with USB interface cable, Software CD, hard carrying case and user manual. | The Amprobe SC-3500 4? Signal Clamp for AT-3500 attaches around a buried metallic pipe, cable, or wire to induce a transmitted signal into the feature for active location and tracing. It does not require direct contact with metal to transmit the signal and can transmit signal through insulation on wires and into cable and wire bundles, providing more accurate tracing than locating with just a receiver and transmitter. Accommodates conductors up to 4? in diameter. Transmits a 33 kilohertz (kHz) frequency supplied by the T-3500 Transmitter (included in the AT-3500 kit). | Universal, economical tachometer measuring rotational or surface speed either in contact or non-contact way. Widely used to measure rotational speed of motors, conveyer belts and other moving or rotating systems. | The AT-7020 Advanced Wire Tracer kit includes the AT-7000-R Receiver and the AT-7000-T Transmitter. The Receiver includes Amprobe?s patented Smart Sensor feature to instantly display the location and orientation of energized wires in walls, floors, and ceilings. You can clearly see the direction of the wire on the large, bright TFT LCD full color display. In hard-to-reach areas, you can use the Receiver?s Tip Sensor to trace wires in corners, tight spaces and junction boxes. The Transmitter offers two automatically-selected frequency modes for optimal tracing on energized and de-energized circuits, and three power modes (high, low, clamp) for a variety of environments. The breaker mode?s Scan and Locate feature identifies the one correct breaker or fuse with the highest recorded signal, thus eliminating the confusion of multiple false positives common with older technology tracing tools. So whether you?re a novice user or an expert, this Amprobe circuit tracer kit will help you get the job done fast. | Use for Wire Tracer series AT-2000 | Eliminate downtime, predict the lifetime of equipment and reduce safety hazards with the Amprobe AMB-110 Insulation Resistance Tester that tests voltage and step voltage to 10,000 V. You can accurately test cables, transformers, motors, surge arrestors and generators in noisy environments such as high voltage switchyards. It also boasts built-in noise rejection filters and shielded test leads to provide high EMI immunity. |
