| Content | Test insulation of wires, cables, transformers and electrical motors quickly and easily with this rugged tester. | TEST LEAD SET FOR INSULATION RESISTANCE TESTERS | The Amprobe TMA40-A provides three measurements in one: Air Velocity or volume, Relative Humidity and Temperature. With three ways to view your measurement results. Choose between single point measurement, multiple points up to 99, or the added feature of data logging up to 2400 data points. User sets the measurement interval time from 1 to 200 seconds. The TMA40-A has a flexible cord to position vane where you need to measure. For accurate CFM results, the user simply inputs the area of the air source. TMA40-A ships with USB interface cable, Software CD, hard carrying case and user manual. | The Amprobe MLS55-3 Pipe transmitter is an optional accessory for the AT-3500 underground cable locator that allows for pinpointing places in pipes, ducts, etc. It can be inserted to the pipe/duct using standard fish tape or a duct rodder and can accommodate pipes over 2? (5 cm) in diameter. | The Amprobe SC-3500 4? Signal Clamp for AT-3500 attaches around a buried metallic pipe, cable, or wire to induce a transmitted signal into the feature for active location and tracing. It does not require direct contact with metal to transmit the signal and can transmit signal through insulation on wires and into cable and wire bundles, providing more accurate tracing than locating with just a receiver and transmitter. Accommodates conductors up to 4? in diameter. Transmits a 33 kilohertz (kHz) frequency supplied by the T-3500 Transmitter (included in the AT-3500 kit). | |
| Additional information |
| Weight |
3 lbs |
| Dimensions |
12.3 × 7.8 × 4.5 in |
|
|
| Weight |
2 lbs |
| Dimensions |
3.3 × 14.5 × 9 in |
|
| Weight |
1 lbs |
| Dimensions |
7.1 × 5.3 × 3.7 in |
|
| Weight |
2 lbs |
| Dimensions |
9.84 × 9.84 × 9.84 in |
|
| Weight |
2 lbs |
| Dimensions |
10 × 5 × 5 in |
|
