| Description | The GLP-1A logic pulser can be used to perform in-circuit testing of TTL, CMOS, and many other logic devices at a maximum of 50MHz. The GLP-1A is enhanced with a logic probe function with a minimum detectable pulse width of 10 ns, providing enough sensitivity for most applications. A Short 10 sec pulse width assures that no damage will occur to circuits whilst testing. With a weight less than 50g, a non-slip grip, and an external sync input, GLP-1A provides comfort and reliability for various troubleshooting tasks. | | | | | |
| Content | | | The GCP-425P four-channel current probe power supplies designed for the GCP-530 and GCP-1030 clamp current probes. The power supplies are ideal for when power is not available from an oscilloscope. Also use for general current measurement applications. | | | With a flat frequency response, low noise and low insertion loss, the GCP-530 and GCP-1030 clamp-on probes are ideal for measuring steady state or transient current in amplifiers, inverters, electric motors, switching power supplies, controllers, sensors, LCD displays and electronic ballasts. For low current measurements, the high signal-to-noise ratio also makes the GCP-530 and GCP-1030 current probes ideal solutions. |
| Additional information |
| Weight |
1 lbs |
| Dimensions |
6 × 8 × 4 in |
|
|
| Weight |
4 lbs |
| Dimensions |
12 × 10 × 6 in |
|
| Weight |
0.3 lbs |
| Dimensions |
7 × 3 × 2 in |
|
| Weight |
0.3 lbs |
| Dimensions |
7 × 3 × 2 in |
|
| Weight |
3 lbs |
| Dimensions |
16.93 × 15.35 × 12.2 in |
|
