| Content | Amprobe?s advanced wire tracer technology combines a Receiver and powerful Transmitter to locate energized and de-energized wires, breakers, and fuses without having to disconnect any equipment. The Receiver features four tracing modes optimized for a range of applications, and the Transmitter utilizes two optimized frequencies that allows for a clean and reliable signal. Whether you?re a novice user or an expert, the AT-6000 Advanced Wire Tracer Series kits will help you get the job done fast. | The Amprobe MLS55-3 Pipe transmitter is an optional accessory for the AT-3500 underground cable locator that allows for pinpointing places in pipes, ducts, etc. It can be inserted to the pipe/duct using standard fish tape or a duct rodder and can accommodate pipes over 2? (5 cm) in diameter. | The Amprobe TMA40-A provides three measurements in one: Air Velocity or volume, Relative Humidity and Temperature. With three ways to view your measurement results. Choose between single point measurement, multiple points up to 99, or the added feature of data logging up to 2400 data points. User sets the measurement interval time from 1 to 200 seconds. The TMA40-A has a flexible cord to position vane where you need to measure. For accurate CFM results, the user simply inputs the area of the air source. TMA40-A ships with USB interface cable, Software CD, hard carrying case and user manual. | If you install or connect 3-phase motors and systems, you recognize the importance of verifying the correct motor rotation and wiring phase sequence. Improper connections can cause motors to rotate in reverse direction, potentially damaging the motor and the equipment it is powering. | The Amprobe TMA-21HW Hotwire anemometer technology eliminates the use of bearings and rotating parts. When compared to standard bearing type probes, the compact Amprobe hotwire sensor is more reliable (no mechanical moving parts) and allows for easier access to duct and confined spaces. The Amprobe TMA-21HW Hotwire anemometer measures air flow volume and velocity, it features a telescopic probe for positioning the sensor, and is used by HVAC/R technicians to measure wind flow and temperature in air conditioning systems. | This affordable and rugged megohmmeter is fast and easy to use, and offer the features you need for most insulation test applications including wires, cables, transformers and motors. |
