| Content | | The ELS2A is for use with all models of clamp meters. It enables the user of a clamp meter to measure the current on a 2-wire or 3-wire power cord to 15 A without having to cut off the plug and separate the conductors, or opening electrical boxes on 120 V lines. The ELS2A also includes a 10X current multiplier loop for increased sensitivity and accuracy of low-current measurements. | The Amprobe MLS55-3 Pipe transmitter is an optional accessory for the AT-3500 underground cable locator that allows for pinpointing places in pipes, ducts, etc. It can be inserted to the pipe/duct using standard fish tape or a duct rodder and can accommodate pipes over 2? (5 cm) in diameter. | The Amprobe PM55A is the ultimate pocket-sized multimeter. Only 3/8? thick and less than 3 oz in weight with full functionality offering AC and DC voltage measurement to 600 V, AC and DC current to 2000 ?A, resistance to 6 Megohm, capacitance to 2000 ?F, frequency to 30 kHz, diode test and continuity with beeper. It also offers VolTect?, a built-in, non-contact voltage detection feature for AC voltages. | ACD-50NAV clamp-on power meter offers AC current measurements to 600 A, AC/DC voltage to 1000 V, and wide jaws to accommodate large conductors. This clamp-on multimeter is ideal for industrial power monitoring and verifying system conditions. | |
| Additional information |
| Weight |
0.5 lbs |
| Dimensions |
9 × 7 × 1 in |
|
| Weight |
1 lbs |
| Dimensions |
7.9 × 5.5 × 1.2 in |
|
| Weight |
1 lbs |
| Dimensions |
7.1 × 5.3 × 3.7 in |
|
| Weight |
1 lbs |
| Dimensions |
4 × 10 × 2 in |
|
| Weight |
1 lbs |
| Dimensions |
15.8 × 11.2 × 7.6 in |
|
|
